Gas check engagement on boolit shank
Hi guys and gals,
I have what might seem like a dumb question. I am installing .30 caliber gas checks from Sage's Outdoors on to Lee TL312-160 boolits, using a Lee .314" boolit sizer. I am finding that if I don't tap the boolit down into the check with a hammer before crimping it on using the sizer, the check doesn't engage as much of the boolit shank. It comes out square and I have fairly consistent boolit length, and they are on there securely, but I am concerned that there is a slight air space between the boolit and the check. Is this something that I should be worried about enough to take some sort of corrective action, or should I just not worry about it?
Scotty