I just finished rehabbing one of these. Now, where do I find nose punches and sizing dies? Thanks in advance for all advice.
Sam
Printable View
I just finished rehabbing one of these. Now, where do I find nose punches and sizing dies? Thanks in advance for all advice.
Sam
Midway, Natchez, Brownells or any other place sell g reloading supplies.
Standard Lyman and RCBS H&I dies and top punches will fit it. I like them better than the 450 or 4500 sizers.
Thank you both very much.
Sam
I’ve seen folks saying here and elsewhere that they like the 45 better than the 450 or 4500, but I’ve never seen them tell why. Since the later ones have cast iron one piece bodies (that have been known to crack) I guess there might be a bit of a durability problem, but is there anything else? It seems like the 45 might be more likely to go out of alignment... a definite negative. What are the positives? Remember cool factor doesn’t count in this discussion, just objective advantages. :coffeecom
Froggie
Froggie asked the question I was wondering as well, why would one prefer the 45 over the later models? Normally I prefer older equipment, made before MIM parts, the rise of plastic, and the designed obsolescence, however the 450 & 4500 don't have any of these issues (other than MIM parts). Please enlighten those of us that don't understand the fascination.Quote:
Originally Posted by Green Frog
The Lyman 45 is not near as robust as the later Lymans or RCBS lube-size machines. I have no idea why folks think they are better. I have been using this gizmos and well over 50 years and the 45 is an inferior machine in terms of strength, alignment and any way you can measure one of these machines. I guess folks think that newer just has to be inferior, but that is not true, at least in this case. I gave my last 45 away years ago and was glad to see it go.
I’ve got three of the old #1 lube sizers that preceded the 45, and although they really look cool I really can’t truthfully say they are in any way superior to the 450 bolted more or less permanently to the bench or its floating, back up brother. The one #1 that gets much use clamps to an oak board that is then clamped into my bench vise on the work bench. 8-)
I’ll listen to what folks have to say about the reason(s) I should seek out a 45. Cool doesn’t count since I have 3 good working examples of the #1. 8-) I want solid objective arguments, please. :coffeecom
Froggie
PS. The OP mentioned trading up to to a Star lube press. Be prepared for a bit of sticker shock. If you get one for on the order of three to four times the cost of a 45, you will have done well. They ain’t cheap!. I just got one in a complicated friends and family deal and felt good when I “only” had about $150 in it. :coffee:
PPS Ignore previous PS… I got cross threaded with another post. [smilie=b: