Where are you guys getting .22 caliber gas checks? Seems like I would need to gas check if shooting .223 out of an AR.
Printable View
Where are you guys getting .22 caliber gas checks? Seems like I would need to gas check if shooting .223 out of an AR.
I've used the Sage copper checks. They fit even after powder coating.Quote:
Originally Posted by pjh421
Thanks! I'll look that up. At rifle pressures, I don't want to get all set up with plain base boolits and find out I should have gone with gas checks.
ETA: Can you offer any opinion on the difference between Sage copper checks and Sage Gator copper checks? I've always used Hornady's but my supply is dwindling. So, for the first time in maybe 25 years I guess I'm in the gas check market.
Well, correctly, I've used the Gators. I didn't realize they sold any other copper checks. I was distinguishing between the copper checks and the aluminum checks they sell. I've run (a different cast bullet) powder coated and gas checked over a full load of W748 in my ARs with no leading.Quote:
Originally Posted by pjh421
I hope it works as well for you.
You might try Sage Outdoors or NOE both handle the Gator brand and both are good to deal with. If you want to run the above 2300 the probably yes, but I load some as low as 1800 fps that still cycle the action using PC without a leading problem.
Please do not offer to sell in this thread as the OP is asking for sources.
My bad. Thanks for the help, AlHunt and Minerat. I will get some Sage Gator Checks. Ordered 1 kg of green metalic from Donnie and a couple bottles of spray lube. Been using Hornady One Shot case wax on Hi Tek coated boolits and it works fine. Maybe the Hi Tek will be even better?
The Hornday checks have a lip inside the check that crimps on to the boolit shank the gators are smoothe. I've never had a problem with the gators staying on either with regular lube, before powder coating or after PC. Sometimes you gave to flair them a little when put on after PCing.