Lee PrecisionTitan ReloadingReloading UKRepackbox
MidSouth Shooters SupplyInline FabricationADvertise hereRotoMetals2

  • M-Tecs's Avatar
    Today, 10:21 PM
    It's been years seen I worked on one but IF I remember correctly it should be 9/16"-24 threads
    2 replies | 18 view(s)
  • country gent's Avatar
    Today, 10:11 PM
    country gent replied to a thread Tonights supper in Our Town
    They seem to give a little better flavor than saltines or bread crumbs. Mom would use the goose eggs up in meat loaf or egg noodles; But a goose egg is to big for just a 1 pound meat loaf
    12 replies | 254 view(s)
  • country gent's Avatar
    Today, 02:57 PM
    country gent replied to a thread Tonights supper in Our Town
    I believe they were a soup spoon that was handy. about the same soup spoon of molasses. the bacon was blended thru when it was all mixed. I usually grab what utensild is handy and work by eye cooking. LOL Everything was in one bowl and mixed...
    12 replies | 254 view(s)
  • country gent's Avatar
    Today, 01:19 PM
    Those arnt bernards or parallel jaw piers since they open with the jaws parallel thru the whole stroke. At first glance I think they may be for installing grommets in tarps and canvas.
    16 replies | 532 view(s)
  • country gent's Avatar
    Today, 12:42 PM
    You lose a lot to the band saw blade. About .040 per cut so every 3-4 cuts youve got a strip in the chip pan. one of the wavy knife edge type bands would be better. A small table top band saw with a rip fence might work.
    8 replies | 130 view(s)
  • country gent's Avatar
    Today, 09:53 AM
    When we were making bacon we always used a big thin bladed knife similar to a fillet fnife that was razor sharp. the block was chilled just short of freeing to stiffen it then a very light coat of cooking oil on the blade sliced nicely but then we...
    8 replies | 130 view(s)
  • M-Tecs's Avatar
    Today, 01:17 AM
    Which movie are your referring too?
    29 replies | 789 view(s)
  • M-Tecs's Avatar
    Today, 12:14 AM
    The cheapest would have been a muzzleloading rifle or shotgun. Any cartridge (at the time) would have been relatively expensive in comparison. Kids guns are mostly a later concept. Old Yeller got that part correct; however, the Travis Coates used...
    29 replies | 789 view(s)
  • country gent's Avatar
    Yesterday, 10:00 PM
    country gent replied to a thread Tonights supper in Our Town
    Well I got the "experts" opinion at dinner time. Daughter her husband and the 3 grandsons stopped in as I was getting ready to eat. The youngest ( 4 years/old) came over and was looking at my plate so I gave him a bite. Big grin and he ran over to...
    12 replies | 254 view(s)
  • country gent's Avatar
    Yesterday, 09:48 PM
    I would start by checking the hammers hit in relation to the face of the nipple also. a lo nipple where the hammer isnt getting a good hard hit may be the problem. A small piece of play dough in the nose of the hammer and fired may show that the...
    11 replies | 219 view(s)
  • country gent's Avatar
    Yesterday, 05:35 PM
    country gent started a thread Tonights supper in Our Town
    Just mixed a small met loaf for supper. 1 lb 80/20 hamburger 1 egg 1 small tube ritz crakers 1/4 teaspoon butter 1 strip of hickory smoked bacon 3 spoons of mild salsa salt pepper and a touch of molasses Will do biscuits and green beans...
    12 replies | 254 view(s)
  • country gent's Avatar
    Yesterday, 09:26 AM
    I can see feeding and functioning issues as that paper jacket is likely to leave a paper ring in the throat when fired. I use cigarette papers as shims and for cleaning measuring faces on mikes and a for setting cutter clearances. most measure...
    6 replies | 170 view(s)
  • M-Tecs's Avatar
    11-25-2021, 03:56 AM
    Basics here but check out the shooter at about the 4:53 mark.
    22 replies | 596 view(s)
  • M-Tecs's Avatar
    11-25-2021, 03:54 AM
    These folks are just shooting for fun.
    22 replies | 596 view(s)
  • M-Tecs's Avatar
    11-25-2021, 03:51 AM
    To be a national level competitor takes an incredible amount of skill and dedication. However, until like most competitive shooting games a lot of people shoot it solely for fun. One gentlemen locally loads his shotshells with real black...
    22 replies | 596 view(s)
  • M-Tecs's Avatar
    11-24-2021, 11:02 PM
    You set the hook well with some. You missed the purple font.
    30 replies | 668 view(s)
  • M-Tecs's Avatar
    11-24-2021, 10:41 PM
    Like others stated the bullet is most likely on the hard side and is it is producing a small hole that is easily plugged with fat.
    29 replies | 844 view(s)
  • M-Tecs's Avatar
    11-24-2021, 10:27 PM
    Ihole is correct. There are two diameters in a barrel. The greater (major) diameter is the groove; the lesser (minor) is the bore. The groove diameter is what you are checking bullet fit against. Good info here...
    30 replies | 668 view(s)
  • M-Tecs's Avatar
    11-24-2021, 10:22 PM
    M-Tecs replied to a thread .30 v .303 in Gas Checks
    Designed for .308" groove diameter barrels verse .311" groove diameter barrel would be my guess but send him an email to get 100% correct info.
    3 replies | 217 view(s)
  • country gent's Avatar
    11-24-2021, 09:53 PM
    Making angle plates, vee blocks and other tooling is much easier if you have access to a rolling saw. The vertical cut off allows you to rough them in in the saw, saving a lot of mill work. I have one set of angle plates 1 1/2" X 2" X 2" with a...
    9 replies | 263 view(s)
More Activity
About Kenny Wasserburger

Basic Information

Date of Birth
July 2, 1962 (59)
About Kenny Wasserburger
Biography:
Wyoming Native 4th Generation Ranch Raised In NE Wyoming
Location:
Gillette Wyoming
Interests:
Long Range BPCR, Paper Patching, Hunting, Fishing, Reading-research,
Occupation:
Level IV Lease Operator Anadarko Petro

Statistics


Total Posts
Total Posts
864
Posts Per Day
0.16
General Information
Last Activity
Today 06:11 PM
Join Date
12-09-2006
Referrals
0

5 Friends

  1. cajun shooter cajun shooter is offline

    Black Powder 100%

    cajun shooter
  2. country gent country gent is online now

    Boolit Grand Master

    country gent
  3. Doc Highwall Doc Highwall is offline

    Boolit Master

    Doc Highwall
  4. longranger longranger is offline

    Boolit Buddy

    longranger
  5. M-Tecs M-Tecs is online now

    Boolit Grand Master

    M-Tecs
Showing Friends 1 to 5 of 5
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check