guninhand
10-08-2006, 10:56 AM
Hi folks,
Just got a new Lyman 12ga slug mold, the air gun pellet style, and am wondering what the screw in the bottom is for. I'm guessing it's for securing the base pin when the mould is in storage. Any special tips apply to getting the best results with this rig, especially as regards pre-heating?
Any particular alloy likely to give best accuracy?
Just got a new Lyman 12ga slug mold, the air gun pellet style, and am wondering what the screw in the bottom is for. I'm guessing it's for securing the base pin when the mould is in storage. Any special tips apply to getting the best results with this rig, especially as regards pre-heating?
Any particular alloy likely to give best accuracy?