Mold for Ruger 450/400?

[LIMPINGJ]

Does anyone know of a mold that is about std wt for this round and has a gc? I think the gc will be needed as I hope to duplicate factory velocity. Maybe any members in AU or NZ know if CBE has a mold designed for this round? I found a 418-410 mold in the CBE catalog said to be for the 416s so might could size that one down as it is about the right wt. Thanks for any guidance.

[Nrut]

LIMPINGJ
I am using the RCBS .416" mold sized down to .413" in my Ruger #1 in .405 Winchester..I lube and check the boolit first in a .418" die then run it thru a push thru type die made by Buckshot..

I haven't played with it that much but that mold shows promise.. I bought it from Buffalo Arms..

[AkMike]

Get a note off to Tom at Accurate molds and tell him what you want. He designed a dual weight 2 cavity mold for my 600 and had it in my hot little hands in about a week. Top quality and it was only $85! Lee 6 hole handles fit also.

http://www.accuratemolds.com/