New ruger

[garbear]

I just picked up a new Rugr sp101 with a 3" barrel. I still need to do the trigger work. I have a lee 358-158 grain rf boolit by lee. Any suggestions for a new mold from BRP. Or maybe a maker who makes brass molds. I prefer the heavier boolits Any suggestions. The lee cast good but after getting a mold from BRP I have decided to not buy lee rather pay for the quality from a make.

[Three-Fifty-Seven]

Contact MiHec, and see if he has a extra of these http://castboolits.gunloads.com/showthread.php?t=90352 BRP also makes it, but not sure of the mold material, or if it is a hp design . ..

I also have the 3.0625" SP101, I put Houges on it . . .

[garbear]

Can you give me a link to his site or a email contact plase

[Groo]

Groo here
Unless you need a real heavy bullet, Hihec has a mold of the 45-2.1 design
2 crimp groove , round nose flat point [about 175 gr] or hollow point [159gr]
with keith lube groove.
This one loooooks Nice..
Speedloader friendly, lever friendly No.# 359640

[Three-Fifty-Seven]

His site:
http://www.mp-molds.com/shopping/pgm-more_information.php?id=15&=SID

The boolit:
http://castboolits.gunloads.com/showthread.php?t=90352

I like MiHec's Brass Crammer HP's, not sure what BRP makes them out of, or if they are hp.

[Wayne Smith]

Old West Molds also makes brass molds, as does the new guy - don't know his name but look for the post on the new mold maker.

[garbear]

Here is my baby

[EOD3]

I also have an SP101 in 357 that's my #1/#2 carry gun.

Wish I knew where to get one of the "X" model hammers. Ruger won't sell them outright. :(