DOUBLEJK
09-08-2006, 08:28 PM
Got a few more shot today in the 1892 20" Short Rifle...
Most accurate load tested yet too...
RCBS180CM...1.575" OAL...23.5 AA#1680...CCI300...StarLine case...1518 f.p.s.
At 50 yds. off my truck bed for a rest 5 went into a group 1-1/4" wide by 2-1/4" tall...:-D
And the fastest load so far also...
RCBS180CM...1.575" OAL...19.0 H2400...CCI300...Win case...1795 f.p.s.
and .5 grain less of the old H2400
RCBS180CM...1.575" OAL...18.5 H2400...CCI300...Win case...1743 f.p.s.
I'm no where near K. Waters load of 22.0 of H2400 that he said was too HOT!!! at 1856 f.p.s. but my velocities are gettin' close..
For reference Lyman #40 shows thier 180gr. PB #40043 as Max at 23.6gr of old H2400 for 1875 f.p.s.
Sure glad I started low or this would have been a disaster I bet...
I aquired a small lot of the Win 180JSP's and tried them with the 23.5 AA#1680 and they went 1557 f.p.s. in a nice round small group too...1-1/8"
Smaller than my best boolit load yet...:twisted:
I think I'll go .5gr more with the old H2400 and see if pressures are too high... the load of 19.0gr was O.K.
On the AA#1680 it can go more to and I have high hopes it will do what H2400 will do and maybe a bit more at less pressure...
Most accurate load tested yet too...
RCBS180CM...1.575" OAL...23.5 AA#1680...CCI300...StarLine case...1518 f.p.s.
At 50 yds. off my truck bed for a rest 5 went into a group 1-1/4" wide by 2-1/4" tall...:-D
And the fastest load so far also...
RCBS180CM...1.575" OAL...19.0 H2400...CCI300...Win case...1795 f.p.s.
and .5 grain less of the old H2400
RCBS180CM...1.575" OAL...18.5 H2400...CCI300...Win case...1743 f.p.s.
I'm no where near K. Waters load of 22.0 of H2400 that he said was too HOT!!! at 1856 f.p.s. but my velocities are gettin' close..
For reference Lyman #40 shows thier 180gr. PB #40043 as Max at 23.6gr of old H2400 for 1875 f.p.s.
Sure glad I started low or this would have been a disaster I bet...
I aquired a small lot of the Win 180JSP's and tried them with the 23.5 AA#1680 and they went 1557 f.p.s. in a nice round small group too...1-1/8"
Smaller than my best boolit load yet...:twisted:
I think I'll go .5gr more with the old H2400 and see if pressures are too high... the load of 19.0gr was O.K.
On the AA#1680 it can go more to and I have high hopes it will do what H2400 will do and maybe a bit more at less pressure...