jmsj
09-04-2010, 12:06 PM
Hey guys,
I could use a little help. I bought the Lee .358-105-SWC mold to make some boolits for my wife to use for practice in her 38 Spl/357 mag CCW pistol.
Cast up about 1000 last night still need to lube them. I just finished making a sizing die and need to find an O-ring to fit the top groove.
My question;
I am planning on using 38 Special cases andthe lightest load of Bullseye powder that shoots decently.
I read the old posts and am a little confused about the C.O.L. If I read correctly some are seating and crimping in the crimp groove, some are using the front driving band and others are seating the nose flush with the case.
Those of you using this bullet w/ light charges, any information would be greatly appreciated. Thanks jmsj
I could use a little help. I bought the Lee .358-105-SWC mold to make some boolits for my wife to use for practice in her 38 Spl/357 mag CCW pistol.
Cast up about 1000 last night still need to lube them. I just finished making a sizing die and need to find an O-ring to fit the top groove.
My question;
I am planning on using 38 Special cases andthe lightest load of Bullseye powder that shoots decently.
I read the old posts and am a little confused about the C.O.L. If I read correctly some are seating and crimping in the crimp groove, some are using the front driving band and others are seating the nose flush with the case.
Those of you using this bullet w/ light charges, any information would be greatly appreciated. Thanks jmsj