jonk
08-18-2006, 01:46 PM
I have the following Lee .30 cal molds for which I would like to know the closest approximate Lyman or RCBS top punch (I have an RCBS Lubrisizer):
Lee 90366- 150gr GC FN
90364- 120gr GC RN
90370- 200gr GC RN
Any thoughts or experience? I'd rather get the 'real' top punch if a good one is available than resort to the JB weld epoxy routine.
Thanks, Jon
Lee 90366- 150gr GC FN
90364- 120gr GC RN
90370- 200gr GC RN
Any thoughts or experience? I'd rather get the 'real' top punch if a good one is available than resort to the JB weld epoxy routine.
Thanks, Jon