View Full Version : pivit pin or pivit screw
pakmc
05-17-2010, 08:20 PM
How do you keep the pivits screw in a Lee two holer??? any body??
IJ'm sure this has been talked about for ever, but I haven't heard it.
Pat
HeavyMetal
05-17-2010, 09:28 PM
Copy any Lyman mold by drilling and tapping a hole, 8-32 is a good size, in the side of the mold where it will intersect the pivot screw.
You'll need to remove the pivot screw first of course then drill and tap.
And drop a shot into the hole so the hard set screw doesn't screw up the pivot screw.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.