Screws for a Williams FP sight

[brianintheup]

I lost the screws to my Williams FP sight does anyone know what the length is on the two 6-48 screws? If not I will get some and cut them to fit. Thanks

Brian

[pmeisel]

betcha if you called Williams they would tell ya. Maybe sell ya the screws cheap too, they are friendly people....

[brianintheup]

Thanks

[redneckdan]

Where in da UP is you? I'm in houghton, I may have an unused set in my pile of odds and ends...somewhere......:groner:

[fecmech]

They are 6-48 X 1/4" on my FP that fits a Win 94 AE

[brianintheup]

fecmech,

Are both of the srews 1/4"?

[Baron von Trollwhack]

Chances are you may have screws for a mount or base that just need the heads turned a little to fit the countersink. BvT

[pietro]

FWIW, receiver sights sometimes take two screws, each of a different length, because one screw will pass through the thicker body of the sight base, with the other passing through the thinner recess for the sighting bar slide.

.

[fecmech]

Both screws for my 94 AE are 6 X 48 X 1/4.

[KYCaster]

I have a 5D and a FP right here in front of me. Both fit Win '94. The bases appear to be identical. On both the screw inside the dovetail cut is .285 and the other is .427 long.

Jerry

[Three-Fifty-Seven]

So Brian, did you get your sight taken care of yet?