.35 Remington boolit?

[troy_mclure]

im looking for a mold for a marlin 336 in .35 rem.

mostly for hunting.

[shooter93]

RCBS 200 grain for a factory mold.

[Glen]

+1 for the RCBS mould. Great bullet for the .35 Remington.

[giz189]

I like it in my 358 Win. Never used it in a 35 Rem though. Should be good IMO.

[Larry Gibson]

+1 on the RCBS 35-200-FN. I cast mine of WW/pb at 50/50 and HP them with a Forster HP tool for hunting. I run them at 2150 fps out of a M91 Mauser with a 26" Shilen barrel. They also shoot very well in Marlins and are recommended by many.

Pictures are;
#1
Loaded cartridge
35-200-FN
Loaded cartridge with bullet HP'd

#2
Texas 8 point I shot with this load last November

#3
Entrance wound

#4
Exit wound

Larry Gibson

[Bret4207]

The RCBS is fine, even better is the GB 35-180 GC/FN that was done some time back. Drops about 190-195 in my alloy and shoots great. Keep an eye out for something like that.

[jlchucker]

Another satisfied user of the RCBS 200 Gr boolit in 35 Rem. By the way, nice deer there Larry.
If you use that RCBS boolit I don't really see a need to buy jacketed ones. While the Coreloct 200 grainer is great in this caliber, Remington must think so too because they've been raising their prices on it to a point where it's more expensive than the competition. Unless their competition casts their own, of course.

[selmerfan]

Another GREAT bullet and specificall designed for the .35 Rem. is Michael "Ranch Dog" Reamy's 190 gr. RGNGC. Here is the link to his site. http://www.ranchdogmolds.com/ Unfortunately the group buy he ran on this mold closed May 1. I ordered a 6 cavity in this group buy and I have a 2 cavity mold of this design that will be replaced by the 6 cav. If you're interested in the 2 cavity mold, shoot me a PM and we'll talk.
Selmerfan