View Full Version : WST in 120gr 38 Spl ?
Evil Dog
05-05-2010, 03:01 PM
Been blindly surfing around for the past hour or two looking for data concerning using Winchester WST with a 120gr RN cast bullet (Lyman # 358242) in 38 Spl. Have found just about everything but. Any of you using WST with this lighter bullet?
Windy City Kid
05-05-2010, 04:14 PM
I have not use the same boolit as yours, but I load two different boolits with the same weight as yours with 3.3grs. of WST
These are little target & Cowboy Action (SASS) loads.
I have had excellent accuracy with these two loads and they are clean burning with low smoke.
.38spl.
Lyman # 358345 mold. (Boolit weight 120gr.)
Lead alloy: WW air cooled.
Sized to .358".
Lube: Carnauba Red lubed only in the bottom groove.
Powder: 3.3grs. of WST.
OAL: 1.365"
Crimp: Light roll crimp
38spl.
Lee .358-125gr.-RF mold. (Boolit weight 125gr.)
Lead alloy: WW air cooled.
Sized to .358".
Lube: Carnauba Red lubed.
Powder: 3.3grs. of WST.
OAL: 1.430"
Crimp: Firm roll crimp
I hope this helps you out.
WCK
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.