View Full Version : Lyman 410639 mould
Kermit2
05-01-2010, 05:06 PM
Could anyone please supply information about this mould? I'm sure it's for .41 magnum bullets. I can't find any information on this mould. What weight bullet will it cast? Is it a gas check type bullet? All information will be appreciated. Thanks.
canyon-ghost
05-01-2010, 06:02 PM
Here ya go, buddy- http://www.three-peaks.net/bullet_molds.htm
Put that page in your favorites list, it's from a blackpowder outfit in Utah. I just bought a NMBH in 41 mag myself.
Ron
Kermit2
05-02-2010, 10:10 AM
Tried that website, but no dice. The Lyman 410639 is not listed there.
Can anyone help out with information on this mould? Thank you.
dakotashooter2
05-03-2010, 04:21 PM
Found this reference on this site...............
I've never run across the TL410-175. I've got a 410639 that is a truncated cone of about 170gr. I use it in my .41AEs and a .41Avenger along with a 185 and 165gr truncated cone from LBT molds. Psst, don't tell fatnhappy, but I've also got a four cavity Lyman 41028 on the shelf, too.
JOE MACK
Expat74
03-06-2014, 02:18 PM
http://bulletmoldblog.com/blog1/2012/09/28/410639-the-41-action-express-bullet/
happend to look for the same.. even if it's been four years since then ;)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.