P-C Moluld

[boatswainsmate]

Has anyone ever heard of this brand? Thanks in advance. Boats

[hammerhead357]

I have. They were based in Pittsburg IIRC. The P-C stood for Pete and Carl I think. Two brothers in partnership. Carl was the machinist of the pair and Pete was the promoter.
While Carl was cutting the moulds they were decent but he quit the company and Pete tried to continue.

I have a single cavity 510 diam. mould that was made by Carl that is pretty good. I then bought a pair of 10 cavity moulds from them that Pete cut, the doggoned things were trash I sent them back and he tried to make them right but it didn't happen. I was out several hundred dollars for the pair and the company had closed its doors so I was left with junk moulds.

So if you have a chance to buy one of the moulds be sure and test it first.

Mike Venturino might see this and chime in here because he got taken in by them too I think...Wes