View Full Version : 308 lee sizer to 310
jcw1970
02-27-2010, 03:19 PM
Is there someone on here i could send my lee sizer to increase the size to .310? I have no skills or tools to do this.
runfiverun
02-27-2010, 07:38 PM
some oil a dowell with a slit and a bit of crokus cloth.
roll it on your leg and try it.
go a bit more.
if still not sure i bet buckshot or lathesmith will open it for you.
Mr Peabody
02-28-2010, 10:18 AM
Lee Precision offers to supply a sizing die of your choice for $25.00 and S&H.
I just got a .361 diameter die from them and it took about two weeks to get it.
You might try them
44man
02-28-2010, 01:20 PM
Go easy, I figure 5 minutes work to go from .308" to .310". I used 400 grit on all of mine, cuts decent and still leaves a good polish.
randyrat
02-28-2010, 01:23 PM
If no one else will do it i will bore it out for you. PM me. I'm no expert at it, but i have done a few of my own to match some grove diameters.
I use 400 grit sand paper then i use 600 and some oil to smooth it out. I'll do it for no extra charge, you pay shipping..
jcw1970
02-28-2010, 02:15 PM
Lee Precision offers to supply a sizing die of your choice for $25.00 and S&H.
I just got a .361 diameter die from them and it took about two weeks to get it.
You might try them
Yeah. I ordered a .278 push through sizer from them. It only took 8 months to get. And inbetween that time i bought a star and had a die for it made. plus i already have this one so i don't want to fork over another $30 to them.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.