inside thread size on RCBS Uniflo

[twotrees]

What size is the inside thread on the RCBS Uniflo powder measure. It's greater than 1/2 inch. but the minor dia measures .513???

9/16ths X ??? 5/8ths X 18 tpi ???

I want to make some spout adapters but need to know this first.

Help Anyone?

Thanks in advance.

[Rat-Man]

If you are talking about the threads at the bottom for the drop tube to thread into, it's 9/16x18.

I just checked this on my Uniflow measure.

Rat-Man

[Le Loup Solitaire]

Yes It is 9/16x18. I took a bolt with this thread and bored it out length-wise with first a 1/4" and then a 3/8" drill, rounded the corners of the hex head until it matched the inside diameter of a Lee powder thru the expanding die and then mounted my RCBS powder measure on it so that the measure sat on/in whatever expand die I was using. If you "cone" the hole that sits up inside of the PM shaft, then the powder drops straight thru then no bridging or hung up grains. LLS

[twotrees]

Thank you both, I'll get busy making some that will fit my setups.