WARD O
02-10-2010, 12:43 PM
I have done much of my casting with a ladle in single/double cavity large bullet moulds - BPCR. Lately I have been buying and using some of the group buy moulds with 5 or 6 cavities and have been trying to use an old SAECO bottom pour pot. I currently elevate this pot about 8" above my bench but
I can not seem to see the spout very easily and have trouble aligning the mould with the spout. Should I elevate it more?
The mould guide with this pot is adjustable for elevation but not width and does not seem to fit any of the moulds I normally use.
Any suggestions on how to make this work more smoothly? What technique seems to work for the rest of you?
Thanks
Ward
I can not seem to see the spout very easily and have trouble aligning the mould with the spout. Should I elevate it more?
The mould guide with this pot is adjustable for elevation but not width and does not seem to fit any of the moulds I normally use.
Any suggestions on how to make this work more smoothly? What technique seems to work for the rest of you?
Thanks
Ward