TORCHrider
02-05-2010, 03:23 PM
Okay, I have decided to cast bullets for my 9mm pistols first and will go after the other calibers later. I have decided to go with the Lee TL356-124-2R mould first because I dont yet have a sizer/lubricator. I am sure I will be buying one sooner or later.
Does anyone have any experience with this bullet (unsized) in the Glock 19 with factory or aftermarket barrel? I know Glock says not to shoot lead bullets in the factory barrel, but I might try it and clean often to see how it works before buying an after market barrel.
I will also be shooting these bullets in a Kahr PM9 and a Sig P239, so if you have any experience with this bullet in those guns please chime in.
Oh, I should also add that I will likely be shooting straight WW or maybe a 75/25 WW and lead mix.
[smilie=s:
Does anyone have any experience with this bullet (unsized) in the Glock 19 with factory or aftermarket barrel? I know Glock says not to shoot lead bullets in the factory barrel, but I might try it and clean often to see how it works before buying an after market barrel.
I will also be shooting these bullets in a Kahr PM9 and a Sig P239, so if you have any experience with this bullet in those guns please chime in.
Oh, I should also add that I will likely be shooting straight WW or maybe a 75/25 WW and lead mix.
[smilie=s: