resizers

[batman]

can you a rcbs rockcrusher press and lee resizing dies.I am going to pan lube.
This is for 357,45 and 44 mag.

[garandsrus]

Yes...

[theperfessor]

Wasn't sure from your post if you mean a push through-type sizing die for bullets from Lee or a cartridge case sizing die. In either case it should work OK. I don't have a Rockchucker but I think it has a threaded bushing that allows it to use standard 7/8-14(?) dies, which I believe the Lee dies use. Almost all commercial threaded dies below .50 caliber use this thread size so dies are pretty well independent of the press you use them in.

Unless there is some sort of length-of-stroke issue I think you're OK. I'm sure somebody that has tried this combination will chime in.

[Cowboy5780]

They work fine i use the combo for part of my boolits

[batman]

thank you

[DLCTEX]

JFYI the Rockchucker press has a removable bushing to enable use of 7/8" or 1 1/4" dies. Or, as I have done, install Hornady Lock-n-load quick change bushings.