Barrel vises & receiver wrench

[Dutchman]

These arrived in a box today from someone who offered them to me gratis (freebie). The maker was a professional machinist. The material is 1.5" thick x 2" wide. Blued steel.

The top is for the Swedish Mauser military barrel. The middle is for the Carl Gustaf m/80 target rifle. The bottom is for the Carl Gustaf m/63 target rifle. I'll probably bore one of them out to take bushings for 98 Mauser barrels. There's also a 1 lb can of powdered rosin and a little jar of barrel assembly paste from Brownell's.

http://images52.fotki.com/v644/photos/2/28344/1676633/DSCF0889bw-vi.jpg

Receiver wrench for the m/96 Swedish Mauser, and will fit all small ring actions I believe.

http://images23.fotki.com/v804/photos/2/28344/1676633/DSCF0897bw-vi.jpg

Everything is stamped with sizes, right & left, including shims between the blocks. This barrel vise is for the Swedish Mauser and was made primarily for m/1894 Swedish carbines but will fit all small ring Mausers. The length of the clamping surface is stamped on the vise in addition to the diameter.

http://images53.fotki.com/v431/photos/2/28344/1676633/DSCF0902bw-vi.jpg

I made this spider a couple days ago.

http://images21.fotki.com/v194/photos/2/28344/1676633/DSCF0941bw-vi.jpg

Dutch

[largom]

Very nice and very lucky you. I would make brass cups to go over the bolt ends on your spider assy.

Larry

[Dutchman]

Yeah, I was going to do something along those lines. Then I remembered I had a big roll of aluminum flashing that can be used as shim for the same thing. I took the easy way:).

Dutch