dk17hmr
05-20-2006, 01:11 AM
I now have 2 molds I went and bought a .452 230 grain lee tl mold. I also have my 9mm lee mold. Both are double cavity and after messing around with them for a few minutes cleaning the oils of them I fired up my pot. It took some getting use to but in no time I had a system working dropping good bullets from the mold into a bucket of water covered by a towel with a cut in it.
This is what I came up with.
http://i48.photobucket.com/albums/f208/dk17hmr/DSCF0041.jpg
Better then 1000 all together about 500 of each.
I have them lubed with lee tumble lube you get in the 4oz bottle and are dryin in our reloading room, and some not pictured on the bar in the family room.
Ok now that I have them lubed tomorrow can I load them and shoot them?
The 9mm bullets actually casted to .358, which is what I wanted so we can load them for my dads 38's with a light 120 grain plinkin load.
The 45's casted at .454. I want to load these for my 45 ACP its a 1911 not a wheelgun Im wondering if they will work out?
DK
This is what I came up with.
http://i48.photobucket.com/albums/f208/dk17hmr/DSCF0041.jpg
Better then 1000 all together about 500 of each.
I have them lubed with lee tumble lube you get in the 4oz bottle and are dryin in our reloading room, and some not pictured on the bar in the family room.
Ok now that I have them lubed tomorrow can I load them and shoot them?
The 9mm bullets actually casted to .358, which is what I wanted so we can load them for my dads 38's with a light 120 grain plinkin load.
The 45's casted at .454. I want to load these for my 45 ACP its a 1911 not a wheelgun Im wondering if they will work out?
DK