BigCheese
05-15-2006, 09:46 PM
The mold guide bar on my RCBS Pro-Melt furnace works well with all my molds except Hensley & Gibbs 4-cavity. These molds have screws protruding from the bottom surface. (The others have screws countersunk). I can't rest the molds on the guide bar and slide them while filling each cavity because the screws hang up on the bar.
Holding the mold above the guidebar gets tiring mighty fast. The two round adjustable wheels are apparently to center different width molds. They are too small in diameter to rest the bottom of the mold on them so that the mold is raised above the guide bar far enough so that the screws will clear the bar.
Any suggestions on what to do. I don't have a machine shop and am not very handy at making parts.
Holding the mold above the guidebar gets tiring mighty fast. The two round adjustable wheels are apparently to center different width molds. They are too small in diameter to rest the bottom of the mold on them so that the mold is raised above the guide bar far enough so that the screws will clear the bar.
Any suggestions on what to do. I don't have a machine shop and am not very handy at making parts.