cheese1566
11-29-2009, 01:38 PM
Does Lar's Carnuba Red contaminate powders?
Specifically from the small amount left on the Lee bevel bases.
I have three pistol molds that are the Lee 6 cavities with bevel bases. They work great and I will refuse to modify them at this point. I have tried wiping the excess lube that inherently gathers on the small bevel base=tired fingers. I also tried the gas check/foam discs in the sizer die. I know there are other solutions, but today that is not my question...:grin:
My light loads are mainly for practice-plinking-and fun in 9mm, 38 special, and 45 Auto using Winchester-Hodgon ball pistol powders.
I have asked this in the past and didn't get much answers. I know I have seen the same post in the last few months, but cannot find it.
Specifically from the small amount left on the Lee bevel bases.
I have three pistol molds that are the Lee 6 cavities with bevel bases. They work great and I will refuse to modify them at this point. I have tried wiping the excess lube that inherently gathers on the small bevel base=tired fingers. I also tried the gas check/foam discs in the sizer die. I know there are other solutions, but today that is not my question...:grin:
My light loads are mainly for practice-plinking-and fun in 9mm, 38 special, and 45 Auto using Winchester-Hodgon ball pistol powders.
I have asked this in the past and didn't get much answers. I know I have seen the same post in the last few months, but cannot find it.