View Full Version : Can gas checks be attached....
MontanaS
11-25-2009, 06:56 PM
...without a die? I do not have a sizer die and was wondering if they could be put on by hand?
yondering
11-25-2009, 07:11 PM
A sizer die is required to crimp the check onto the boolit. Checks are oversized as they come out of the box, loading a boolit without a crimped check will result in poor or non-existent case neck tension.
Lee push through sizers work fine, and are only $15 or so.
some are actuall on sell right now at midwayusa.
http://www.midwayusa.com/Search/#lee lube____-_1-2-4_8-16-32
Andy
semtav
11-25-2009, 08:43 PM
...without a die? I do not have a sizer die and was wondering if they could be put on by hand?
I'll go thru my selection of reloading dies and see if there is a die that will fit. I used a 243 resizing die to put my gas checks on until my 6.5 die showed up.
(I'm guessing MS is on a mission to get some 8mm bullets loaded for the Milsurp match Saturday)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.