View Full Version : Lee Loader
I have a fine old Lee Loader that seems to be missing something behind the washer on the capper piece. (Put your primer in and whack it in place). Looking at it I assume it's a spring/wavey washer or something, but I've never seen one. I can tickle the washer out revealing a spot such a thing could be placed. Has anybody ever repaired one of these? What type of part should I be looking for? 8 or 9 repeated calls to Lee has resulted in only busy signals.
JIMinPHX
11-09-2009, 11:53 PM
You didn't say what caliber it was. Here is the Lee parts page for the .38 Special Lee Loader -
http://www.leeprecision.com/cgi/catalog/parts.cgi?1257825085.5169=90257
You can click on individual part numbers for pictures of the parts.
The parts pages for other calibers can be found here -
http://www.leeprecision.com/cgi/catalog/browse.cgi?1257825085.5169=/html/catalog/cleeloader.html
Are you sure that you are missing something? Did you read the directions? I think that you usually sit the primer down in a hole & then put the brass on top of a spring loaded disk, & then hammer the brass down or something like that. It's been a while since I've used one of them.
Thanks, Jim. That's the point, the spring loaded disk has no spring. Thanks for the parts reference. that shoud fix me right up.
725
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.