AJ Peacock
11-05-2009, 03:58 PM
OK,
I've read and read and read and searched but haven't been able to find the answer (I think [smilie=1:).
I've been casting 220gr .338's and sizing them GC'ing them. I am now contemplating PP'ing for the rifle.
How far undersized should a boolit be before you start PP'ing them? Lee makes 2 potential push through sizers (.323 .329), The reading I've found so far points to around .007-.008" PP increase. So the .329 would patch up to .337" or so, which is a tad too small.
Would the .329 be too small? Or is it typical to patch up more than .007-.008" ?
Could I get the .329 and polish it up a couple thousandths?
Thanks for any info,
AJ
I've read and read and read and searched but haven't been able to find the answer (I think [smilie=1:).
I've been casting 220gr .338's and sizing them GC'ing them. I am now contemplating PP'ing for the rifle.
How far undersized should a boolit be before you start PP'ing them? Lee makes 2 potential push through sizers (.323 .329), The reading I've found so far points to around .007-.008" PP increase. So the .329 would patch up to .337" or so, which is a tad too small.
Would the .329 be too small? Or is it typical to patch up more than .007-.008" ?
Could I get the .329 and polish it up a couple thousandths?
Thanks for any info,
AJ