Star Sizer die housing O-ring

[IllinoisCoyoteHunter]

I managed to mangle one of the two o-rings in the sizer die housing when removing a die last night too quickly. I called magma and they told me the o-ring is a #116 o-ring. I started looking online for o-ring kits and was wondering if anyone knew the specifications on this size o-ring (ie ID, width, etc). These o-ring kits give sizes, but they don't use the numbers. Any help would be appreciated. Thanks!

[GabbyM]

your local ag equipment shop should have them for about fifty cents. They are 3/4".

have you tried running it without the O ring? Mine tore the top o ring on the first day and hasn't had one in since. top and bottom are both gone. it does leak a little. I keep forgeting to buy some and I was even into our Massey Ferguson dealership last week buying bolts.

[IllinoisCoyoteHunter]

Thanks gabby!

[jeffwhetstone]

ILCoyoteHunter,

I always mangle the o-rings....so I layed into a big stash here:

http://www.amazon.com/Black-EPDM-Rub...8662326&sr=8-1

100 should hold ya for a while.

Jeff

[Muddy Creek Sam]

116 Black EPDM Rubber O-Ring 70A Duro, 3/4"ID x 15/16" OD x 3/32"W

[GabbyM]

ILCoyoteHunter,

I always mangle the o-rings....so I layed into a big stash here:

http://www.amazon.com/Black-EPDM-Rub...8662326&sr=8-1

100 should hold ya for a while.

Jeff

See how you all are. I've 150 o rings ordered now. Got 100 of the black ones then 50 silicone just to see how they worked. Shippng cost more than the o rings. not hard to do since the o rings were less than 2 cents each.

[jsizemore]

Got mine at Lowe's today. Danco #14 10 pack $1.98. Part # 96731. 15/16" O.D.X 3/4" I.D. X 3/32".

[TAWILDCATT]

a lot of the parts are of the shelf at hardwares.:coffee: