bbs70
10-26-2009, 07:53 PM
From what I've read here a lot of people use alox to pan lube their boolits,
I also use this method with a Lee push through sizer.
I got to wondering if it would make a difference if I use a lubrisizer to get lube into the grooves, or just continue using the pan lube to lube the bearing surface of the boolit.
I cast for a 45 Colt and a 40 cal auto.
I got to thinking if the lube grooves had lube in them, it would form a seal when the boolit was on the way down the barrel.
Or would it make any difference.
I also use this method with a Lee push through sizer.
I got to wondering if it would make a difference if I use a lubrisizer to get lube into the grooves, or just continue using the pan lube to lube the bearing surface of the boolit.
I cast for a 45 Colt and a 40 cal auto.
I got to thinking if the lube grooves had lube in them, it would form a seal when the boolit was on the way down the barrel.
Or would it make any difference.