kbstenberg
09-27-2009, 08:15 PM
I finally got my R RH last week. Now the work begins. I slugged the cylinders, the measurements are .429 / .429 / .428 / .4285 / .429 / .4285 The barrel measures .4275. I used case lube to lubricate bullets that were WW alloy.
From my reading i should start with a bullet sized to .430. Correct? I already heve cast a couple different bullets so far. A Lee and a Lyman that i have cast are at .429 they are lubed with LLA when they are put into the cylinder it only takes a lite finger pressure to push them through the cylinder throat. Is it supposed to take more than lite pressure to prevent leading?
I am really antsy to make some loads an try it out!!!!!!!!!!!
Could someone out there with more experiance useing a caliper measure my sluged bullets to see if i am correct on my measurements?
From my reading i should start with a bullet sized to .430. Correct? I already heve cast a couple different bullets so far. A Lee and a Lyman that i have cast are at .429 they are lubed with LLA when they are put into the cylinder it only takes a lite finger pressure to push them through the cylinder throat. Is it supposed to take more than lite pressure to prevent leading?
I am really antsy to make some loads an try it out!!!!!!!!!!!
Could someone out there with more experiance useing a caliper measure my sluged bullets to see if i am correct on my measurements?