View Full Version : 32 Cal Ideal Heel Molds
6pt-sika
04-07-2006, 08:06 PM
I cast and load for the 32 Long Colt , so I can shoot my 1892 Marlin. I already have Ideal mold #299153 . I would like to get mold #299155 , this is an 80 grain heel mold. Anybody got any ideas on where I can get one ?
Bret4207
04-08-2006, 06:41 AM
I think Rapine still makes that general design. Also, look at the RCBS 310 Cadet mould. I'm not sure of the diameters, but it might be workable.
JeffinNZ
04-09-2006, 10:46 PM
http://www.castbulletengineering.bigpondhosting.com/custom.htm
Try Jim Allison in Australia.
cheers
J
Harry O
04-10-2006, 08:11 PM
NEI Handtools makes a heel-base .32 Long Colt bullet. It is #78B. It is 0.313"OD, is 95grains, and is heel-base.
Cast Bullet Engineering has the largest selection of .32 Long Colt bullets. They have one in 92gr, one in 106gr, and one in 120gr. All are 0.315"OD and have a heel-base. It does not appear that the .310 Cadet bullets will work. The ones they list for this are 0.320"OD.
Andy_P
01-09-2010, 08:48 AM
NEI Handtools makes a heel-base .32 Long Colt bullet. It is #78B. It is 0.313"OD, is 95grains, and is heel-base.
Does anyone happen to know what diameter the "heel" is?
I have some Dixie Gun Works brass (that uses 22 blanks) and it seems to require a heel of about 0.284". The brass is turned, so would not be friendly to flaring.
Anyone else use the Dixie brass?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.