kywoodwrkr
08-11-2009, 05:57 PM
I'm busy resizing a bunch of 40 S&W brass.
Everytime I size a Blazer or Federal case, the primer sticks on the decapping pin and then is 'reset' into the primer pocket.
I then have to jiggle the case to make the primer 'fall' out. Usually on the floor!:-?
I'm using a Lee sizing die.
Anyone have a solution to this sticking?
Is this a function of the design of the anvil in the CCI and Federal primers?
Hate to have to watch each case to se if primer pops out on upstroke.
Been double stroking when no primer snaps right out and this has helped, but Blazer and Federal are a real PITA.
Comments?
Everytime I size a Blazer or Federal case, the primer sticks on the decapping pin and then is 'reset' into the primer pocket.
I then have to jiggle the case to make the primer 'fall' out. Usually on the floor!:-?
I'm using a Lee sizing die.
Anyone have a solution to this sticking?
Is this a function of the design of the anvil in the CCI and Federal primers?
Hate to have to watch each case to se if primer pops out on upstroke.
Been double stroking when no primer snaps right out and this has helped, but Blazer and Federal are a real PITA.
Comments?