Littledog
08-10-2009, 09:04 PM
I was going through some of my dad's old bullet casting equipment and came across an old RCBS 115 grain conical 2 cavity bullet mould. This mould has got to be at least 30 years old and I was wondering if anyone has any experience with it.
I cast for many calibers but the 9mm isn't one of them and I was wondering if I could get some suggestions as to alloy hardness, sized diameter and powder selection, (I currently have plenty of Titegroup, HS6 and 700X). I'd like to cast up a few and try them in my Browning Hi-Power and Berretta 92. Thanks much.
I cast for many calibers but the 9mm isn't one of them and I was wondering if I could get some suggestions as to alloy hardness, sized diameter and powder selection, (I currently have plenty of Titegroup, HS6 and 700X). I'd like to cast up a few and try them in my Browning Hi-Power and Berretta 92. Thanks much.