.357 sized down to .355

[BT Sniper]

I have been on the side lines a lot lattly here but looking into my next project. Anyone taking a .357 bullet and pushing it through a bullet sizer to end up with .355 bullets?

Bt

[deltaenterprizes]

There should be no problem with that.

[sargenv]

I recently took .358" moly coated lead and put them through a Lee .357" sizer with no issues. Slid right through without too much effort.

[turbo1889]

I size 0.311" and 0.312" jacketed bullets down to 0.309" with a Lee push through sizer all the time for use in my CZ-52, 7.62x25 caliber. A lot of the 32-revolver bullets work great in that cartridge just need a little size down first. Use the same lube on them that you use to full length resize brass an it will all work out just fine.

[StarMetal]

I'm sure you know this, but thought I'd mention it, when sizing beyond the norm always be sure to have lube in the groove. When you size a bullet the metal moves to another place. With lube in the grooves it prevents the metal from making the groove smaller.

Joe

[BT Sniper]

Thanks guys I should have mentioned jacketed bullets. I noticed Lee only has .356 to size down to. Would this work for a 9MM?