Any Ideas on where to get 18 thread pitch dies

[jla4570]

I have been speaking with Dr. Blackmon (who has been alot of help) and the dies that I need for my press are not the size that he makes. I am looking for a source of dies that have an 18 thread pitch. Does anyone have any ideas short of custom Corbin dies? Or should I start looking at another press? Any press recommendations on the press?

[BT Sniper]

What caliber bullet you making? I would imagine a press may be cheeper then custom dies but it all depends on again what bullet you are making. What press has an 18 thread pitch?

Good luck

[jhrosier]

Try here: www.mcmaster.com

Jack

[ANeat]

It may be easier to modify the press or make an adapter or threaded insert...

[jla4570]

What caliber bullet you making? I would imagine a press may be cheeper then custom dies but it all depends on again what bullet you are making. What press has an 18 thread pitch?

Good luck

I was looking to start with 22 but I am thinking that a new press may be in order.

[deltaenterprizes]

What is the diameter of the dies?

[jla4570]

The dies are 5/8 in diameter