jcdean
06-15-2009, 09:38 AM
I am new to casting so educate me a bit if you would.
My new mold is casting out at about .451 using WW and my slugged barrel wants .452.
These are going to be cowboy rounds, so I am not looking for one hole groups. But, is this going to be an issue?
I am using the Red Rooster Zambini lube in my lubrisizer and it is leaving a small ring on the bevel base and a bit of a smear on the sides as well. They are just not filling the sizing die.
Figure I need to ask now instead of regret it later.
My new mold is casting out at about .451 using WW and my slugged barrel wants .452.
These are going to be cowboy rounds, so I am not looking for one hole groups. But, is this going to be an issue?
I am using the Red Rooster Zambini lube in my lubrisizer and it is leaving a small ring on the bevel base and a bit of a smear on the sides as well. They are just not filling the sizing die.
Figure I need to ask now instead of regret it later.