HammerMTB
06-14-2009, 11:10 PM
I am casting from a Lee 90337, a 240 gr SWC gas-checked style mold. I am shooting lower velocities and don't think a gas check is needed. All that is working fine. BUT- I am lubing from a 450 sizer and just let lube in where the GC would be.
WHAT A SMOKESCREEN!
It looks like I'm shootin' BP!
Got any suggestions on how I can keep lube out of the GC band? I've been toying with cutting a little piece off a .44 brass and leaving it in the bottom of the sizer die. My guess is that after a while it will load up with lube and I'll have to clean it out.
BTW, my first post here. Been reading and lurking a few days. Great site, lots of info!
WHAT A SMOKESCREEN!
It looks like I'm shootin' BP!
Got any suggestions on how I can keep lube out of the GC band? I've been toying with cutting a little piece off a .44 brass and leaving it in the bottom of the sizer die. My guess is that after a while it will load up with lube and I'll have to clean it out.
BTW, my first post here. Been reading and lurking a few days. Great site, lots of info!