C & H die

[Kragman71]

Hello
I noticed a C & H swaging die on e bay,marked 3575.
It looks very much like a Herters base die/body die.
Does any one know if it is for 35 cal bullets?
Will it fit my Herters Super tool?
thanks
Frank

[Adam10mm]

Probably makes .3575 bullets. Ruger's are cut to .3575" grooves.

[Kragman71]

Probably makes .3575 bullets. Ruger's are cut to .3575" grooves.

FS
Thanks for the input.
Do you know the Outside diameter of the C&H dies;or if they fit into Herter's tools?
The Herter's die looks similar and the greater diameter is .827;the lesser one is .717.

Frank

[Adam10mm]

I have a set of CH4D 101 series dies for 10mm swaging. They are 7/8-14 threaded. Try to thread the die in that press. My math tells me 7/8 is .875". Might be a smidge too big.

[Kragman71]

These dies are different,entirely.
They are not threaded;they are held in place with a 'collar'that screws into the base,where the ram is located.They form the base of the bullet.
The nose forming dies are threaded.They screw into a 'body'die,that is 7/8"threaded.
The cup die also fits the Herter's Nine Ton Tool,but the nose punch is different.
A seperate die is needed for each shape of nose.

Frank

[Adam10mm]

Then I don't know. I've never seen the type of dies you are talking about.

[Kragman71]

Thanks,for your help.
I searched further,and found a picture of a Swage o Matic tool with dies.
Although the cup dies look similar,they are different.
No sale