housedad
05-26-2009, 08:26 PM
I have been buying lead WW recently, and I finally found some time last night to start going through the ton or so.
I found some ingots, molded in a lyman mold. About 50 of them.
I do not know what they are for sure, but there were a couple of wads of lead and clips at the same level.
Should I hit them with a hardness tester? What do you think I should do to minimize any zink that could be in there?
I just don't know what to do with them to ensure they are OK. I don't know what they consist of. They could be the guys personal mix for all I know.
Please advise me with what to do. Thanks
Bion
I found some ingots, molded in a lyman mold. About 50 of them.
I do not know what they are for sure, but there were a couple of wads of lead and clips at the same level.
Should I hit them with a hardness tester? What do you think I should do to minimize any zink that could be in there?
I just don't know what to do with them to ensure they are OK. I don't know what they consist of. They could be the guys personal mix for all I know.
Please advise me with what to do. Thanks
Bion