View Full Version : sharp shooter mould question
par0thead151
05-07-2009, 10:06 AM
i have just begun casting for 00 buckshot with a sharp shooter mould i bought. i noticed that during my second casting session, that one of the alignment balls had fallen out. i need to find it (its in the bucket of water where i quench my shot) what would be the best route to insure i do not have it fall out again?
thanks
jsizemore
05-07-2009, 07:05 PM
did you contact Rick aka skiesunlimited?
email address: skiesunlimited@att.net
Rick told me if I had a problem with my molds to contact him and he would take care of it. He or his wife have responded to me quickly.
Good Luck
par0thead151
05-08-2009, 11:17 AM
just emailed him,. thanks for the address.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.