CH4D Champion & the 404 Jeffery?

[abosely]

I am thinking about getting a CH4D Champion Press.

But I can't find out the measurement of the ram stroke I've seen it
listed as 3 1/4", 3 3/4" and 4 1/2". But I did read that the 3 1/4" one was a typo.

Or the size of the opening in the ram area.

Does anyone have those dimensions?

The main thing that I'm trying to find out is can I load 404 Jeffery rounds on it?
If it can be done is it a reasonable fit or is it a fight to get it in and out?

The 404 Jeffery is just under 3.6" COL about the same length as the .375 H&H.

What is the longest cartridge anyone has loaded on a CH Champion?

Allen

[Gary51]

Call Dave at C&H, he is the owner and is a wealth of knowledge and a heckua nice guy and very accessible.

[quasi]

Mine has a stroke of 4 1/4". I have loaded a few hundred jacketed .375's and over a thousand cast cartridges on it, as well as several hundred .340 Weatherby loads. It works fine on these long cartridges, you will be amazed how ergonomic it is.

[abosely]

Thanks quasi,

That's what I needed to know!

You wouldn't happen to have a picture or two of the Champion with a .375 H&H size round in it or being loaded that you could post would you?

Allen