Swage-O-Matic dies, nose punches

[Danth]

Hello All: Other than the few remaining parts @ CH, does anyone know of a source for Swage-O-Matic dies and nose punches? Thanks, Dan

[mikenbarb]

CH4D still has some stuff in stock for a few calibers but I think thats about it for parts except auction sites. I bought most of his .30cal stuff last week. Think they still have some 38 and 45 stuff laying around and possibly a few .30cal punches.

[kawalekm]

Talk to Rob at CH4D. I spoke with him and said that he had a whole draw full of swagomatic parts. I ordered several .45 caliber punches for 5$ each.

[pjh421]

Sounds like a custom niche market for guys like Buckshot and Lathesmith.

Paul

[TAWILDCATT]

I have two presses.seems like a good idea to make new ones.there are many more people reloading then when the press first came out.I used to cast 38 WC and run in the press,just to bump them a bit.any imperfections disapeared.they would be great to swedge odd size bullets.:coffee:[smilie=1:

[Sixgun Symphony]

Since C H tool & die is partnered with 4D Custom Die, will they make custom swaging dies for the Swage-O-Matic press?

[Pystol]

I have four working Swag-a-matics.... Cups for 44 cal, 45cal,& 30 cal... My problem is I have tons of those cals made up, and I shoot mainly 357 cal... where is everyone getting their cups (Jackets). I really need to know. If you've a mind too, drop me a email at Pystol1@yahoo.com... Thx much.. Hope you can help me

[TAWILDCATT]

did you try CORBIN

[Pystol]

Corbin is very expensive.... was looking to get them cheaper.
Thx