daboone
04-08-2009, 12:22 PM
I use the Lee 9mm seating die for both FMJ and my TL356-124-TC. I've read several threads for using epoxy and other fixes for non RN designs. My OALs are more consistent with the epoxy fix.
I'd like opinions about this idea. I sized down slug to snugly fit in the seater. (I also cut it down to about 1/4 inch long.) Dropped it in and put the stem back and adjusted it to the OAL I wanted. It seems to work but you folks might see a problem I don't. ????? It would be easier than removing the epoxy each time I switch.
I'd like opinions about this idea. I sized down slug to snugly fit in the seater. (I also cut it down to about 1/4 inch long.) Dropped it in and put the stem back and adjusted it to the OAL I wanted. It seems to work but you folks might see a problem I don't. ????? It would be easier than removing the epoxy each time I switch.