Texasflyboy
02-13-2006, 08:26 PM
I am at the beginning of crafting my second "big" casting pot and wanted to know if any of you have suggestions for making a taper hole and countersink?
I would prefer to make it myself. I have access to a drill press, welding machine, etc.. but not a lathe or mill.
I would also like to know what the design of a taper hole and countersink look like.
Here is what I think they look like:
http://users2.ev1.net/~eastus1/A/sprue.jpg
I would prefer to make it myself. I have access to a drill press, welding machine, etc.. but not a lathe or mill.
I would also like to know what the design of a taper hole and countersink look like.
Here is what I think they look like:
http://users2.ev1.net/~eastus1/A/sprue.jpg