IllinoisCoyoteHunter
03-30-2009, 10:30 PM
I have a Lee 358-158-RF mold and find that when seating my boolits for both 38spl and 357 mag I am having to go under the suggested Min OAL to get the case mouth at the crimp groove. Is anyone else having this problem? Thanks in advance guys!! BTW I am using titegroup...if that helps. I am using 158 grain LSWC data. Do you think it is safe to crimp it to the groove? I am worried I may have a bad mold.
If someone could give me the spes on their boolits dropped from this same mold I would sure appreciate it. Mainly concerned about base to top and bottom of crimp groove. Thanks
1
If someone could give me the spes on their boolits dropped from this same mold I would sure appreciate it. Mainly concerned about base to top and bottom of crimp groove. Thanks
1