Murphy
02-09-2006, 12:19 AM
Hi guys,
I have often wondered how others go about cleaning out the vent lines in their boolit moulds.
For all my years of casting (20), I have used a single edge razor blade, or a disposable box cutter knife with segments you break off as the tip dulls. I would follow the vent lines carefully from the cavity to the edge of the mould block.
Guys, one of the reason's I became a member of this site is to learn. I figure there are other methods that may never have occurred to me in this area.
Let's hear it...*smile*.
Respectfully,
Murphy
I have often wondered how others go about cleaning out the vent lines in their boolit moulds.
For all my years of casting (20), I have used a single edge razor blade, or a disposable box cutter knife with segments you break off as the tip dulls. I would follow the vent lines carefully from the cavity to the edge of the mould block.
Guys, one of the reason's I became a member of this site is to learn. I figure there are other methods that may never have occurred to me in this area.
Let's hear it...*smile*.
Respectfully,
Murphy