View Full Version : Buckshot - "T" slot for reloading bench?
JCherry
04-08-2005, 04:46 PM
Buckshot,
Some time back you posted some photos of a "T" slot you use on your reloading bench.
Does your "T" slot just slide in or is anything used to "lock" or tighten it into place?
Have Fun,
JCherry
Buckshot
04-09-2005, 03:15 AM
.................. It just slides in, but I'd suggest a pin on a chain (string, rawhide thong, whatever) to use as a lock. I have a couple units that want to move out during use. Seems odd to not have the time to chuck up a 1/4" bit and drill down through a inch and a half of wood for even a carriage bolt[smilie=b: , but there you have it.
................Buckshot
JCherry
04-11-2005, 12:50 PM
Ok, I think I got you. Basically the "T" slot needs to be a close fit with some sort of pin to keep it in place. I figure on making a couple of these on my bench. Making them interchangable should not be too much of a problem.
Thanks, JCherry
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.