NM Ruger SBH Hunter dimensions

[arcticbreeze]

Can someone who has a New Model Super Blackhawk Hunter with the rings mounted tell me the distance between them? (from inside to inside)I have looked all over Rugers site and googled from H3LL and beyond and can't find it.[smilie=b: I am getting conflicting info. I am trying to figure out if the ultra dot will fit the factory set up.

[44man]

I no longer have a Hunter or SRH here but I think the Ultra Dot will fit. I measured the turret on my Ultra Dot 30mm for you and it is 1-13/16" so if the spacing is a little longer between your rings, you are OK.
Be aware if you buy the 30mm you need larger rings and Ruger does make them.
The 1" Ultra Dot might even have a smaller turret.
I don't think the Bushnell will fit at 1-15/16"

[buck1]

Super Blackhawk Hunter .44 mag............
I dont have a scope on it right now but CTC of the Ruger dovetail cuts on the BBL are... 2.565"
Hope this helps.....Buck

[lathesmith]

The inside edge-to-edge distance between rings on my Ruger SBH Bisley Hunter is 1.885". So it would appear that 44man called it--the 1-13/16 distance will work, but a 1 -15/16 is too wide.
lathesmith