saeco lock ring die

[primersp]

hello
is somebody knows the size of a nut for remplacing the alu lock ring die
thanks for our answer
regards
ANDRE

[oneokie]

7/8-14 tpi

[primersp]

hello
sorry but 7/8 14 is the size for standard reloading die
the saeco sizer die is more small about 0.620 mike .
thanks

[No_1]

If you are talking the sizer dies, I did a quick measurement of a handful and found the outside diameter is between .680 and .690. This does not correlate to any standard or metric size on my charts. The thread pitch gauge indicates 24 tpi as far as these old eyes can tell.

Robert

[BABore]

It's 11/16-24 thread.

[primersp]

ok thanks for ours answers
n° 1 & BABore
i try to find one 11/16 -24

[BABore]

Good luck on finding a nut. I called Redding/Saeco and got a spare. Ask for Bruce Merkur (IIRC). He's their Saeco parts guy. They cost 4-5 bucks. I got mine for free when I expalined to him how it was all stripped out. Laid it on real thick.[smilie=1:

[primersp]

mine the outside serrated is a bit worn
and i have seen on ebay a sellor who have
the saeco sizind die with a nut ,and idea comes
i try to find here on motorcycle or boat shop
or e-bay england.i'm not sure than saeco sends outside few years later i made the leather grease gasquet .

thanks
regards
ANDRE